130mm / 53mm OJ Logo 1t/2w/4b Assembly Silver Bullet Skateboard Trucks
Skateboard Truck / Wheel completes by Bullet are a great, affordable way to get skateboarding and learn the basics. These Bullet truck assemblies come with 53mm OJ Wheels and Abec 3 bearings. OJ's provide a smooth roll while still performing at the skate park. Beginners look no further! Get skating quickly with these radical set ups.
What Size Trucks Do I Need For My Board?
Need some help deciding what trucks to put on your board? We’re here to help! You will notice that there are some areas of overlap on the deck width side of things. There are area’s where more than one size of truck will fit. It really comes down to personal preference, and can also depend on what size wheels you ride. Don’t stress too much about it though. Use this chart as a guideline, and you’ll be shredding in no time!
|6.20 - 7.60||109 / 6.90 axle||-||110 / 6.90 axle or 120 / 7.20 axle|
|7.40 - 7.80||129 / 7.60 axle||7.6||130 / 7.60 axle|
|7.80 - 8.20||139 / 8.00 axle||8||140 / 8.00 axle|
|8.10 - 8.50||144 / 8.25 axle||8.25||140 / 8.00 axle or 150 / 8.50 axle|
|8.25 - 8.65||149 / 8.50 axle||8.5||150 / 8.50 axle|
|8.60 - 9.00||159 / 8.75 axle||8.5||150 / 8.50 axle|
|8.90 - 9.50||169 / 9.125 axle||-||-|
|9.50 - 10.50||215 / 10.00 axle||-||-|
*Deck range recommendation varies depending on type and width of wheels
Do I Need Riser Pads?
When running certain combinations of trucks and wheels sometimes it becomes necessary to use riser pads to avoid ‘wheel bite’. Don’t know what ‘wheel bite’ is? Well consider yourself lucky. Wheel bite is what happens when you turn your board and your wheel touches the deck. If you do this hard enough the wheel will ‘bite’ and stop rolling. This often means that you go flying off your board. So if you’re running bigger wheels make sure to read through this chart. While it might look like homework it’s definitely more fun than hitting the pavement!
|Truck Height**||Wheel Range***|
|48.5 - 52||49 - 53|
|52 - 53.5||51 - 55|
|53.5 - 55||53 - 57|
|60||55 - 59|
**You can find truck height information in the 'Details' area a specific truck page.
***Wheel size recommendation with no riser.
What Size Hardware Do I Need For My Board?
When attaching your trucks to your board you’re gonna want to make sure your bolts are long enough. If you use risers, you’ll want to run a longer bolt, but you don’t want to go too long or your setup will look all goofy! Use the chart below and everything will fall into place.
|Wheel Size||Riser Size||Hardware Size|
|7 ply deck||9 ply deck|
|49 - 55||-||7/8"||-|
|55 - 58||1/8"||1"||-|
|57 - 60||1/8" - 3/8"||1 1/4"||1 1/4"|
|60 - 65||3/8" - 1/2"||1 1/2"||1 1/2"|
No Reviews Yet | Add Your Review